Local in Arlington, TX

Open every day, 7 AM – 10 PM

Insured & bonded

Crownline Chimney Sweep

Gas log installation Arlington TX

Gas Log Installation in Arlington, TX: Vented and Vent-Free Sets Fitted Right

A new gas log set turns a fireplace you never use into one you light every cold night with a switch. Crownline Chimney Sweep sizes the set to your firebox, installs it in Arlington with a free estimate and a written price, and refurbishes older sets that still have life in them.

  • Vented and vent-free gas log sets, sized to your firebox
  • Free estimate and written price before work
  • Crew with 20+ years in Arlington homes, insured and bonded
  • Old gas logs refurbished when a new set is not needed

Open every day, 7 AM – 10 PM

Vented gas log set burning in a brick fireplace

The Fireplace You Never Use Because Wood Is a Hassle

Plenty of Arlington homes have a fine brick fireplace that has not seen a fire in years. Buying wood, hauling it in from the garage, getting it lit, cleaning out the ash, and worrying about the sparks is more trouble than a few cold nights are worth. A gas log set changes that. Flip a switch or press a remote, and you have a fire in ten seconds that goes out just as fast.

Crownline Chimney Sweep installs gas logs in Arlington, TX from our office at 700 Highlander Blvd near the Parks Mall. Our crew has fitted gas log sets into Arlington fireplaces for more than 20 years, from the 1950s brick fireboxes around UTA to the factory-built units in Southwest Arlington. The estimate is free, the price is in writing, and we are insured and bonded. Call (817) 505-4222 any day, 7 AM to 10 PM.

Gas Log Installation Services in Arlington, TX

New vented gas log sets. The most realistic flame. Tall yellow fire, glowing embers, logs cast from real wood. Vented logs burn with the damper open and send their heat up the chimney, so they are for atmosphere, not for warming the room. They need a chimney that draws, which we check before we quote.

New vent-free gas log sets. Smaller blue-and-yellow flame, but real heat into the room, and no chimney draft needed. Vent-free logs have an oxygen sensor that shuts the gas off if the room air gets low. They are common in Arlington homes from the 1990s and 2000s and in rooms where the chimney is unlined or capped.

Refurbishing an old gas log set. Many Arlington fireplaces have a set from the 1990s that still works but looks tired: faded logs, a lazy flame, embers that no longer glow. We clean the burner, replace the embers and the rock wool, swap a worn pilot or thermocouple, set the logs back in the manufacturer’s pattern and tune the flame. Half the cost of a new set and most of the result.

Controls and remotes. Match-lit burners, millivolt burners with a wall switch, and remote controls with thermostats. We install and pair them.

Converting a wood fireplace to gas logs. Sweep, inspection, damper stop, log set, leak test. If the chimney needs work first, you hear it from us before you buy logs.

Gas fireplace repair. If your existing gas logs will not light, start with our gas fireplace repair in Arlington: the service call is free, and a weak thermopile or dirty pilot is a quick fix.

How We Install Gas Logs in Arlington

  1. Free estimate visit. We measure the firebox, check for a gas stub and a key valve, look up the flue, and test the damper. On a masonry fireplace we also look at the firebox mortar and the smoke chamber.
  2. Pick the set. We show you two or three options that fit the firebox and your venting: vented or vent-free, size, log style, controls. You get a written price for each.
  3. Prep the fireplace. If the flue needs a sweep, it gets one first. We clear the old grate, ash and any old burner.
  4. Install the burner and grate. Level, centered, connected to the stub with a flex line and a shutoff. Every joint is leak-tested with solution and a detector.
  5. Set the logs and embers. Logs go in the exact pattern the manufacturer specifies. A log set out of pattern soots, smells and can crack. Embers and sand or vermiculite go in last.
  6. Damper stop and first lighting. Vented sets get a damper stop. We light the set, adjust the air shutter, pair the remote, and show you how to run it and how to shut the gas off.
  7. Photos and paperwork. You get the manual, the written invoice matching the written estimate, and photos of the finished set.

Most gas log installations in Arlington take two to three hours. If a licensed plumber has to run a gas line first, we schedule the installation for after that work is done.

Vented vs. Vent-Free Gas Logs: Which One for Your Arlington Home

Vented gas logs Vent-free gas logs
Flame Tall, yellow, realistic Shorter, blue-and-yellow
Heat into the room Little Most of it
Damper Open, with a damper stop Closed
Chimney needed Yes, in working order No draft needed
Smell and moisture None in the room Slight smell, adds humidity
Run time As long as you like Limited; follow the manual
Best for Looks, a masonry fireplace with a sound flue Heat, rooms where the chimney is sealed or unlined

Our honest take for Arlington: if the fireplace is in the main living room and you want it to look like a wood fire, choose vented. If you want the gas logs to heat a bedroom or den on a cold night, choose vent-free, keep the burner clean and the logs in pattern, and never run it with the room sealed up. We will tell you which one your fireplace can take after the free estimate visit.

What Moves the Price of Gas Log Installation in Arlington

  • The set. Size, realism and brand. An 18-inch basic vented set costs far less than a 30-inch set with hand-painted logs and a remote.
  • Controls. Match-lit is cheapest, a wall switch costs more, a remote with a thermostat costs the most.
  • Gas supply. If there is a stub in the firebox, the installation is simple. If a plumber has to run a line, that is a separate bill from the plumber.
  • Chimney condition. A flue that needs a sweep or a damper that needs repair gets quoted alongside the logs. See our damper repair in Arlington for the common fixes.
  • Firebox condition. Cracked firebrick or failed mortar must be fixed before any fire, gas or wood.

For reference, HomeAdvisor’s June 2026 fireplace remodel guide puts switching a wood fireplace to gas at $500 to $5,500 and a dedicated gas insert at $2,000 to $5,000. Crownline quotes your exact set and installation in writing after the free estimate. Seniors, veterans and first responders get 10% off, and we match written quotes from insured companies. One discount per job.

Gas Logs in Arlington’s Fireplaces, by Neighborhood

The 1950s and 1960s brick homes around Old Arlington, Fielder Park and UTA have large masonry fireboxes with clay-lined flues. They take a vented set beautifully, and most already have a gas stub from a conversion decades ago. We check the old stub and valve before we trust them.

The 1970s and 1980s ranch homes in Dalworthington Gardens and Pantego are a mix of masonry and early factory-built fireplaces. On the factory-built units we check the manufacturer’s label, because many allow only a specific size or type of gas log.

The 1990s and 2000s two-story homes in Southwest Arlington, Interlochen and near Lake Arlington often have vent-free sets already. These are the ones we refurbish most: a cleaned burner and fresh embers bring them back.

In Viridian and North Arlington the newer homes have direct-vent gas fireplaces with a sealed glass front. Those take no gas log set at all; the logs are part of the unit, and we service them under gas fireplace repair.

Safety Rules We Follow on Every Gas Log Installation

Gas logs are safe when they are the right set for the fireplace, installed to the manufacturer’s instructions, and vented the way they were designed to be. The chimney standard, NFPA 211, covers the chimney and vent side of the job, and the manufacturer’s manual covers the set. Our rules on top of those:

  • Vented sets always get a damper stop, and we leave it in place.
  • Every connection is leak-tested before the first lighting.
  • A firebox with cracked brick or missing mortar gets repaired before logs go in.
  • We confirm a working carbon monoxide alarm is in the home before we leave.
  • Gas supply line work is done by a licensed plumber, as Texas law requires, and we coordinate the timing with yours.

A yearly fireplace inspection keeps the set running clean. Pair the gas logs with a fireplace inspection each fall and the burner, logs, damper and flue are checked together.

Why Arlington Homeowners Choose Crownline for Gas Logs

Crownline Chimney Sweep is the best chimney company in Arlington for gas log installation because we treat it as fireplace work, not a product sale.

  • 20+ years in Arlington homes. We know which 1960s fireboxes draw well and which 1990s prefab units take only one size of set.
  • Insured and bonded. Proof on request.
  • Free estimate, written price. The invoice matches the estimate.
  • Chimney checked first. We look up the flue before we sell you logs.
  • Refurbish before replace. If your old set can be brought back, we say so.
  • Discounts. 10% seniors, 10% veterans and first responders, price match. One discount per job.

Gas log installation sits inside our full list of fireplace services in Arlington, TX. If you are also thinking about a new surround or a full insert, see fireplace remodeling and fireplace installation. Call (817) 505-4222 or send the form below for a free estimate on gas logs in Arlington.

Questions

Gas Log Installation Questions From Arlington Homeowners

How much does it cost to get gas logs installed in Arlington?

The set itself drives most of the price. HomeAdvisor's June 2026 fireplace guide puts a switch from wood to gas at $500 to $5,500 depending on the set, the controls and whether a gas line already reaches the fireplace. Crownline looks at your firebox first, helps you pick a set, and gives you one written price for the set and the installation. The estimate is free.

How much do new logs cost for a gas fireplace?

A basic vented set with a match-lit burner costs the least. Price rises with the size of the set, how realistic the logs look, and the controls: match-lit, millivolt with a wall switch, or a remote with a thermostat. Vent-free sets cost a little more because of the oxygen sensor and safety parts. We show you two or three options that fit your firebox and quote each in writing.

Who should install gas logs?

A fireplace or chimney company that checks the flue and damper first, sizes the set to the firebox, fits the damper stop, and leak-tests the connection. In Texas, any work on the gas line itself must be done by a licensed plumber. Crownline installs the set from the fireplace valve inward and will tell you if a plumber needs to run or move the line first.

Will Lowe's or Home Depot install gas logs?

The big-box stores sell log sets and some refer installation to third-party contractors. What they do not do is inspect your chimney and damper, check the flue draws, or size the set to a masonry firebox built in 1965. If you already bought a set, we are happy to install it after we check that it fits your firebox and your venting.

Vented or vent-free: which is right for my Arlington fireplace?

Vented logs look like a real wood fire, burn with the damper open, and need a working chimney. They are for looks, not heat. Vent-free logs burn clean with the damper closed, put real heat into the room, and need no chimney draft, but they add moisture and a faint smell and cannot run for hours in a sealed room. Most Arlington brick fireplaces take either; we check the firebox size and your chimney before we recommend one.

Can my old gas logs be refurbished instead of replaced?

Often, yes. If the logs are intact and the burner is sound, we clean the burner ports, replace the embers and rock wool, replace a worn pilot or thermocouple, reset the logs in the right pattern and adjust the air shutter. The fire looks new for a fraction of the cost of a set. If the logs are crumbling or the burner is rusted through, we tell you plainly and quote a new set.

Do I need a gas line to the fireplace first?

Yes. Most Arlington homes built after the 1970s already have a gas stub in the firebox, often with a key valve on the wall or floor. If yours does not, a licensed plumber runs the line and we install the logs after. We can check for a stub on the free estimate visit and tell you what you have before you buy anything.

Does the damper have to stay open with gas logs?

With vented logs, yes, always. Vented sets produce carbon monoxide like a wood fire, so we install a damper stop that keeps the damper from closing all the way. That is also why vented logs are not a heat source. Vent-free logs are designed to run with the damper closed, which is where their heat comes from. Direct-vent gas fireplaces have no damper at all.

Can you convert my wood-burning fireplace to gas logs?

Yes, if the chimney and firebox are in good shape. We sweep and inspect the flue, check the damper and the firebox, confirm there is a gas stub, and then install the set. A cracked flue or a firebox with failed mortar gets repaired first, because gas logs do not make a bad chimney safe. The inspection photos tell you exactly where you stand before you spend money on logs.

Related services

More Fireplace Services From Crownline Chimney Sweep

Free estimate

Need Chimney Service in Arlington? Call Crownline Chimney Sweep.

Call for a sweep, an inspection, a repair quote or a gas fireplace that will not light. We answer locally and give you an appointment window on the first call.

  • Local Arlington crew, 20+ years in Arlington homes
  • Insured and bonded
  • Written price before work, free estimates on repairs
  • Discounts for seniors, veterans and first responders
Call (817) 505-4222

Request a Free Estimate

Tell us what is going on. A local person calls you back fast.

Faster by phone: (817) 505-4222 (7 AM – 10 PM, 7 days)

Call (817) 505-4222Free Estimate

Full sweep, level 1 inspection and a photo report.

Call to claim: (817) 505-4222